What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
14.06.2025 03:45

the problem then depends on "how fast does the fuse operate?".
so, what happens?
a photo is worth a thousand words.
What is the difference between Michael Corleone’s marriage to Apollonia Vitelli and Kay Adams?
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
2024–10–16 [ OO OLAOYE OYEBODE ]
One
This is the picture of an electronic coil of wire wound around a core of magnetic material.
So, the voltage could go up to 500 volts, and the fuse will not open up.
The MOV will conduct when the voltage exceeds 50% of line voltage.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
The other is “what does a “fuse” do?”
These devices are installed between the “hot” and “neutral” and protective ground.
2024–10–10[John johnson John Johnson ]
But it can get overloaded, and no longer works.
Was Jimmy Carter a good President of the United States?
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
First Sentence:
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Image of giant volcano on Mars captured by NASA orbiter - ABC News
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
This device then solves the entire problem.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Why do most Indian women cuckold or cheat on their husbands?
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
2024–10–14 [Omar Gharbi Omar Gharbi ]
The bolt then partially travels down the line to your home.
For this case there are devices called Metal oxide varistors (MOV).
Here is a simplified AC power diagram.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
Why do all the stupid people think Donald J. Trump is stupid?
This one hit behind the barn.
It seems Mohan does not understand the difference between a comment and an Answer.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
He then describes the function of a fuse.
At one ohm, the resistor has a maximum of 1 watt power.
What was the worst decision you ever did?
In schematic diagrams this is the symbol for a fuse:
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
This is 'the assistant's answer'
but this device (an Inductor) … impedes the rapid changes in the current.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Is it true that LGB should drop T?
This is where this question deviates from being a 'generic' question, and becomes more specific.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
A circuit breaker is similar, but is resettable.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
This is where the MOV conducts again, and dissipated the energy.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
Now when you have a certain ac resistance, then a current flows in a loop.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
It also is a device that limits the change in current flow.
(Dc diagram shown, AC is similar).
eight
Can the fuse protect the electronic devices from lightning instead of a surge protector.
He then describes Rainy Season and Lightning.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
He then asserts :
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
What does a fuse do?
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
But… the neutral is now “floating” because of the 1 ohm resistance.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
There are three different concepts here that are getting confused.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
nine
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
Upvotes:
A fuse is a non-resetable over current circuit protector.
One is “what exactly is in a ‘surge protector’ ? ”
[image of Common-mode choke]
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
At least they know the answer if they wanted it.
I post the exact comment here.
what exactly is a ‘surge’ protector?
Because the load is inductive, the current lags the voltage.(by a bit).
The third is lightning and “how it gets conducted into a home.”
What is lightning?
Edit 2024–10.
but I think this circuit , shows a few more pieces.
[old diagram got deleted by accident]
Barnstars:
These are simplified answers to the original question, and does not change anything I wrote above.
An AC voltage/ current source, and an ac inductive load.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
There are two important concepts here.